Speed Controller Features
High rate (10 KHz) switching (PWM)
3 to 6 Li-poly cells with receiver.
Dynamic braking ensures prompt prop folding.
BEC (2.0A) provides power to receiver and servos.
Over temperature protection.
User programmable Features.
Low-voltage protection - Programmable
Cutoff can be programmed for motor stop or reduced power.
Brake Type.
Throttle Range.
Timing Advance.
Safe power onarming program.
Low torque “soft start?prevents damage to fragile gearboxes.
Auto shut down in 4sec after signal is lost or radio interference becomes severe.
Microprocessor controlled.
Programmable rotation.
Specifics;
Max Load : 90A
Max Voltage : 6 cell 25v
BEC: 3A
As with all BESC using over 3cells, we urge you to dissable the BEC and use a seperate BEC or UBEC to power the Rx. This is the safest option.
Kommentaar van enkele klanten :
1) Très bon controleur !
super qualité pour le prix !
Je l 'utilise avec le HXT 50/55 B 400 Kv, sur un Katana 2kg200. conso 40 Amp
avec une 13 x 8 APC E.
2) I have two of these, one in a prop model and one in a HET F18 EDF.Prop setup pulls 53a and EDF 44 amps on 3s. BEC fine with 3 GWS park servos and lots of stick thrashing! F18 has input leads extended to 10 inches, with no problems from input capacitors after 15 or so full power flights. At this price you can have plenty of reserve amp handling resulting in cool running, and PC programming is highly recommended. Very good value
3) Great product for a low cost esc!!! Works with my spectrum DX6i.
Programming is easy by the usb programmer and its very light and small. Its less than 50g and with wires is about 26x15x80mm.
Has a non-programable soft-start of about 2s, great to avoid damage in mechanical parts, but be prepared to the delay in response of the throtle, but its no problem to me.
Thats a great low cost esc!! 5 stars!!!